News-Ruito dental medical equipment

Dental X-ray machine may cause electromagnetic interference to other devices by air or by connecting cables.EMC refers to the ability of the device to suppress the electromagnetic interference of other devices without causing similar electromagnetic interference to other devices. The product design according with YY0505-2012 class 1, type A standard.Comply with the following EMC electromagnetic compatibility radiation and electromagnetic immunity declaration.Product basic performance1.Product working principleHigh voltage generator provide high voltage on both ends of the X-ray tube filament and a metal target, X ray tube cathode filament produced a large number of electrons in a vacuum tube high-speed movement, hit the metal target, to produce...

Because the dental comprehensive treatment chair is a necessary equipment for dentists to treat patients, the utilization rate is high. It is also a device that integrates gas, water, and electricity. Daily maintenance is directly related to the length of equipment life and the equipment integrity rate, so daily maintenance work is particularly important.1: First is the maintenance of the mobile phone. It is a key component of the dental comprehensive treatment chair. During use, in order to avoid cross-infection between patients, the mobile phone must be sterilized by high temperature and high pressure. In order to extend the service...

When purchasing an dental LED light curing machine, you should pay attention to the problem of LED overheating and light intensity decreasing too fast with time. This is actually a heat problem of LED. In order to obtain the large light energy output of the LED, the driving current of the LED must be increased as much as possible, but if the driving current is too large, the LED will generate serious heat, which will greatly shorten the service life of the LED and even burn the LED. When purchasing, it can be tested from two aspects. First, after working...

  The main function of the halogen light cold light curing lamp is to polymerize the light curing composite resin material to meet the needs of repairing the defect of the anterior teeth, and beautifying and beautifying the teeth. When working, according to the thickness of the curing material, choose a reasonable curing time, press the trigger switch, the electronic switch circuit will work, and output a control signal to trigger the thyristor electronic device to turn on, so the 12V voltage is applied to the halogen bulb to make It glows brightly, passes the effective light of a specific...

Dental handpiece maintenance note tips: 1 When using the handpiece, it must be lubricated strictly according to the instruction manual. Generally, the high-speed handpiece is lubricated twice a day. Low-speed handpiece (straight machine, curved machine, motor) once a day.2 The working pressure of the dental handpiece must be strictly in accordance with the instructions. In general, the working pressure of two-hole and three-hole dental handpiece is 2-2.2Kg, and the working pressure of four-hole, five-hole, and six-hole dental handpiece is 2.4---2.5Kg (refers to the pressure at the interface between the handpiece and the connecting pipe). The pressure must be adjusted when the new treatment...